Please help. My landlords table saw won’t raise the blade higher than 2 inches. (Picture of underside included) : HomeImprovement

Hello handy people,

I’m trying to lower the legs on a table but the table saw won’t raise above an inch or two and the legs are at least 3″ in length and width. The blade will also lower much farther down than the surface of the table. When I look under I see a bolt that the crank turns that pushes the saw up and down. I’d like to adjust this bolt somehow so that the saw raises higher. Here is a link to the bolt. Thanks for any help on this!

P.S. Sorry for the state of the table saw. It’s not mine. I’m going to clean it up for this project.

Source link

We will be happy to hear your thoughts

Leave a reply
Enable registration in settings - general